Tanaka TLE-550 Manual Do Utilizador
www.tanakapowerequipment.com 4 custsvc@tanaka-ism.com
Owner’s Manual
TLE-550
III. ASSEMBLING PROCEDURES
1. HANDLE ASSEMBLY
a. Install the right handle onto the brackets which are attached to the left handle using 2 pcs. 6 x 35
bolts, 2 pcs. 6mm nuts and 2 pcs. 6mm washers. (Fig. 1)
b. Install handle A onto handle holders A and B by using 2 pcs. 8 x 20 bolts and 2 pcs. lockwashers.
Bend the lock washers against the bolt head after tightening. Next secure handle A with the locking
knobs, 2 pcs. 8mm washers and 2 pcs. 8mm spring washers. (Fig. 2)
c. Install the assembled upper handle with 4 pcs. 6 x 18 bolts, 4 pcs. 6mm washers and 4 pcs. 6mm
nuts. (Fig. 3)
NOTE: Handle height can be changed by loosening and tightening locking knobs.
bolts, 2 pcs. 6mm nuts and 2 pcs. 6mm washers. (Fig. 1)
b. Install handle A onto handle holders A and B by using 2 pcs. 8 x 20 bolts and 2 pcs. lockwashers.
Bend the lock washers against the bolt head after tightening. Next secure handle A with the locking
knobs, 2 pcs. 8mm washers and 2 pcs. 8mm spring washers. (Fig. 2)
c. Install the assembled upper handle with 4 pcs. 6 x 18 bolts, 4 pcs. 6mm washers and 4 pcs. 6mm
nuts. (Fig. 3)
NOTE: Handle height can be changed by loosening and tightening locking knobs.
2. WHEEL INSTALLATION
a. To install the front wheel, first remove the front wheel shaft. Then while holding the wheel in place,
re-install the front shaft using wheel spacers on both sides. Secure with 8mm nut, 8mm washer
and 8mm spring washer. (Fig. 4)
and 8mm spring washer. (Fig. 4)