Shindaiwa LE254 Manual Do Utilizador

10

Slide the ignition switch to the “I” 

1. 

(ON) position.

OFF

Idle the engine briefly before stopping 

(about 2 minutes), then slide the igni-

tion switch to the “O” (Engine OFF) 

position.

NEVER operate the unit with the cut-

ting attachment shield or other protec-

tive devices removed!
Use only authorized Shindaiwa parts  

and accessories with your Shindaiwa 

edger. Do not make modifications to 

this unit without written approval from 

Shindaiwa.
ALWAYS make sure the cutting attach-

ment is properly installed and firmly 

tightened before operation.

NEVER use a cracked or warped cut-

ting attachment: replace it with a ser-

viceable one.
ALWAYS make sure the cutting attach-

ment fits properly into the appropriate 

attachment holder. If a properly installed 

attachment vibrates, replace the attach-

ment with new one and re-check.
ALWAYS stop the engine immediately 

and check for damage if you strike a 

foreign object or if the unit becomes 

tangled. Do not operate with broken or 

damaged equipment.

NEVER allow the engine to run at high 

RPM without a load. Doing so could 

damage the engine.
NEVER operate a unit with worn or 

damaged fasteners or attachment 

holders.

WARNING!
A cutting attachment shield 

or other protective device is no 

guarantee of protection against rico-

chet. YOU MUST ALWAYS GUARD 

AGAINST FLYING DEBRIS!

Open the choke, put the throttle trig-

2. 

ger in the full throttle position, then 

clear excess fuel from the com-

bustion chamber by cranking the 

engine several times.

If the engine still fails to start or fire, 

3. 

refer to the troubleshooting flow 

chart at the end of this manual.