Roberts Gorden CTCU 32 Manual Do Utilizador
SECTION 12: U
SER
I
NSTRUCTIONS
25 of 42
SECTION 12: USER INSTRUCTIONS
12.1 User Instructions
The CTCU heaters are fully automatic and operate
from the external controls fitted on site.
from the external controls fitted on site.
The only user controls at the heater are the:
Burner Lockout Reset Button:
See Page 26, Section 12.3.2
Limit Thermostat Reset Button:
See Page 25, Section 12.3.1
See Page 26, Section 12.3.2
Limit Thermostat Reset Button:
See Page 25, Section 12.3.1
12.2 Heater Operation
When the heater has been switched on by the
remote controls installed on site, the main burner will
automatically turn on.
remote controls installed on site, the main burner will
automatically turn on.
The burner control box will control the safe ignition
of the flame.
of the flame.
All heaters require a constant gas and electricity
supply which must not be interrupted during the
normal operation of this heater.
supply which must not be interrupted during the
normal operation of this heater.
Figure 13: Heater Operating Sequence
12.3 Common User Controls
12.3.1 Fan Thermostat
The fan thermostat is located inside the access door
at the top of the heater.
at the top of the heater.
This control ensures the heater does not blow cold
air in the normal heating cycle.
air in the normal heating cycle.
DANGER
Electrical Shock Hazard
Disconnect electric before service.
Heater must be properly grounded.
Failure to follow these instructions can result
in death or electrical shock.
in death or electrical shock.
Fire Hazard
Keep all flammable
objects, liquids and
vapors the minimum
required clearances to
combustibles away
from heater.
objects, liquids and
vapors the minimum
required clearances to
combustibles away
from heater.
Some objects will catch
fire or explode when
placed close to heater.
fire or explode when
placed close to heater.
Cut/Pinch Hazard
Wear protective gear
during installation,
operation and service.
during installation,
operation and service.
Edges are sharp.
WARNING
Failure to follow these instructions can result in death, injury or property damage.
Burn Hazard
Allow heater to cool
before service.
before service.
Tubing may still be hot
after operation.
after operation.
Explosion Hazard
Turn off gas supply to
heater before service.
heater before service.