Euphonix 5B Manual Do Utilizador
System 5-B Digital Audio Mixing System Operation Manual
Channels and Strips
104
Right-to-mono: Press the lower key next to the Bal knob to send the right
channel equally to both the left and right sides of the stereo channel.
channel equally to both the left and right sides of the stereo channel.
Both-to-mono: Press both keys next to the Bal knob to send a mono mix of
both channels equally to both sides of the stereo channel. The Bal knob then
adjusts the mix between left and right channels.
both channels equally to both sides of the stereo channel. The Bal knob then
adjusts the mix between left and right channels.
•
Swap: Press the lower key to reverse the left and right channels.
Signal Processing In/Out
Press the X key (once from the B Input page, twice from the A Input page) to display the
Signal Processing In/Out page. The four lower knobs show the four processors; the
signal path is from top to bottom. Press the lower button to the left of the knob to toggle
the In/Out status of that processor; the switch lights when the processor is in.
Signal Processing In/Out page. The four lower knobs show the four processors; the
signal path is from top to bottom. Press the lower button to the left of the knob to toggle
the In/Out status of that processor; the switch lights when the processor is in.
NOTE: The function In/Out switches to the left of the Strip’s function switches also
toggle the processors In/Out.
See Section 8.4.2 on page 115 to learn how to change the processor order.
8.3.2
Dynamics
Each channel has a compressor/expander/gate with an external key input. Press the
Dyn function key to assign Dynamics to the knobset; the TFT display at the top of the
Strip shows the dynamics graph (yellow when dynamics are In, gray when bypassed).
The red dot is a GainBall that shows the signal’s current gain (y-axis) and the attack
and release times as the ball rides up and down the curve.
Dyn function key to assign Dynamics to the knobset; the TFT display at the top of the
Strip shows the dynamics graph (yellow when dynamics are In, gray when bypassed).
The red dot is a GainBall that shows the signal’s current gain (y-axis) and the attack
and release times as the ball rides up and down the curve.
The Dynamics section may be switched in/out with the Dyn In key to the left of the
Strip’s function keys. The Expander/Gate and Compressor can be switched in/out indi-
vidually on their respective knobset configuration pages. Use the knob to adjust the pa-
rameters. Each section discusses the effect, if any, of the switches.
Strip’s function keys. The Expander/Gate and Compressor can be switched in/out indi-
vidually on their respective knobset configuration pages. Use the knob to adjust the pa-
rameters. Each section discusses the effect, if any, of the switches.
NOTE: The Dynamics processor can be set as either Expander/Gate or Compressor
but not both simultaneously. Turning on one function while the other is active
will switch off the other function.
will switch off the other function.
The first Dynamics page (Figure 8-10) shows the controls for the compressor. Press the
X key to display pages with the parameters for Expander/Gate and Sidechain.
X key to display pages with the parameters for Expander/Gate and Sidechain.
See Section 8.4.1 - Channel Patch Points to see how to patch the sidechain, which can
be fed from any source. Patching the sidechain can also be done in PatchNet.
be fed from any source. Patching the sidechain can also be done in PatchNet.