Samson EXL250 Manual Do Utilizador

The underside of the Expedition contains a 1-3/8" stand mount socket that allows it 

to be raised up on any standard speaker pole mounting (such as the Samson TA50 or 

TA100 speaker stands). Pole-mounting is generally advis-

able when you want to maximize the distance that the 

Expedition covers (sometimes called speaker “throw”).

If you are using a dB1500a subwoofer, you can use its inte-

gral pole mount with the Samson TS20 speaker stand to 

place an EXL250m or EXL250e immediately above it, creat-

ing a complete column of sound.

Use common sense when setting up speaker stands. 

Whenever pole mounting cabinets, make sure all fasteners 

are tight (or to the manufacturers specifications) and the 

stand can support the weight of the cabinet. 

Set speakers and stands away from areas where people 

will be, taking care that stands will not be knocked into 

possibly causing injury from falling or tipping. 

WARNING! Pole mounting of cabinets should be done by 

qualified personnel.  

Samson assumes no responsibility, personal liability or 

liability for Expedition cabinets.

As shown in figure 1 on the left, the top panel of the Expedition EXL250, XPL200 and 

XPL300 provides a pre-wired compartment that accommodates any of three different 

Samson wireless receivers: the UM1 or AM1 UHF models. Output signal from a wireless 

receiver mounted in an EXL250 arrives at channel 2 of the onboard mixer.

1  Remove the Wireless Compartment Cover by lifting it off the compartment located on 

the top of the Expedition. (see figure 1)

2 Gently take out the power and audio cables from the compartment.

3 Connect the power cable to the DC input jack on your Samson VM1, UM1 or M32 

Receiver. 

4 Connect the audio cable to the audio out jack on your Samson VM1, UM1 or M32 

Receiver. 

5 The audio signal from the receiver is sent to channel 2 on the XPL300 mixer.

ENGLISH

18