Ryobi RY15550 Manual Do Utilizador

6 — English

Tine Size ....................................................................... 8 in.
Tilling Depth ...........................................................7-3/4 in.
Tilling Width .............................................................7-10 in.
Weight ................................................................... 13.5 lbs.

See Figure 1.
The safe use of this product requires an understanding of 
the information on the product and in this operator’s manual 
as well as a knowledge of the project you are attempting. 
Before use of this product, familiarize yourself with all oper-
ating features and safety rules.

This product requires assembly.


  Carefully remove the items from the box. Make sure that 

all items listed in the packing list are included.

Do not use this product if any parts on the Packing List 

are already assembled to your product when you unpack 

it. Parts on this list are not assembled to the product by 

the manufacturer and require customer installation. Use 

of a product that may have been improperly assembled 
could result in serious personal injury.



  Inspect the product carefully to make sure no breakage 

or damage occurred during shipping.



  Do not discard the packing material until you have care-

fully inspected and satisfactorily operated the tool.



  If any parts are damaged or missing, please call 

1-800-860-4050 for assistance.

Ryobi

®

 Expand-it

™

 Tiller Attachment 

J-Handle with Mounting Hardware 
Hitch Pins (2)  
Felt Washers (2) 
Outer Tines (2)
Inner Tines (2)
Operator’s Manual

If any parts are damaged or missing, do not operate this 
product until the parts are replaced. Use of this product 
with damaged or missing parts could result in serious 
personal injury.

Do not attempt to modify this product or create acces-
sories not recommended for use with this product. Any 
such alteration or modification is misuse and could result 
in a hazardous condition leading to possible serious 
personal injury.

Do not connect to power head until assembly is complete. 
Failure to comply could result in accidental starting and 
possible serious personal injury.

See Figure 2.
NOTE: Install the tines before the attachment is connected 
to the power head.
The tiller has four tines —two inner tines labeled B and C, and 
two outer tines labeled A and D. For correct operation of the 
unit, the tines must be installed in the correct orientation.


  Place tine C on the tine shaft to the left of the gear box. 

The stamped side of the tine should face away from the 
gear box. 



  Place tine B on the tine shaft to the right of the gear box. 

The stamped side of the tine should face away from the 
gear box.



  Place a felt washer on each side of the tine shaft, and 

slide to rest against the inner tines.



  Place the outer tine labeled D on the left side of the tine 

shaft. The stamped side should face in toward tine C.



  Place the outer tine labeled A on the right side of the tine 

shaft. The stamped side should face in toward tine B.

 

NOTE:  When installed correctly, the angled edge of the 
tine blades should face the ground.



  To secure the tines to the tine shaft, insert the hitch pin 

into the holes located on either side of the tine shaft.