Datalogic Scanning I GD4100 Manual Do Utilizador

Wedge Quiet Interval

Product Reference Guide

Wedge Quiet Interval

This option specifies the amount of time to look for keyboard activity before the reader breaks
the keyboard connection in order to transmit data to host. The selectable range for this feature is
from 0 to 990ms in 10ms increments.

NOTE

Follow these instructions to set this feature:

1. Determine the desired setting in milliseconds.

2. Divide the desired setting by 10 (setting is in 10ms increments). Pad the result with lead-

ing zeroes to yield two digits. For example: 0 = 00, 5 = 05, 20 = 20, etc.

3. Scan the ENTER/EXIT PROGRAMMING MODE barcode to enter Programming

Mode.

4. Scan the barcode: SELECT WEDGE QUIET INTERVAL SETTING.

5. Scan the appropriate two digits from the keypad in

Appendix E, Keypad

, that represent the

duration which was determined in the steps above. You will hear a two-beep indication
after the last character.

NOTE

6. Scan the ENTER/EXIT PROGRAMMING MODE barcode to exit Programming

Mode.

This completes the procedure to set the Wedge Quiet Interval. See Table

for some examples

of how to set this feature.

Table 14. Timeout Setting Examples

This feature applies ONLY to the Keyboard Wedge interface.

If you make a mistake before the last character, scan the CANCEL
barcode to abort and not save the entry string. You can then start
again at the beginning.

STEP

ACTION

EXAMPLES

Desired Setting

10ms

150ms

600ms

850ms

Divide by 10 (and pad with

leading zeroes)

Scan ENTER/EXIT PROGRAMMING MODE

Scan SELECT WEDGE QUIET INTERVAL SETTING

Scan Two Characters From

Appendix E, Keypad

‘0’ and ‘1’

‘1’ and ‘5’

‘6’ and ‘0’

‘8’ and ‘5’