Lexmark C522 Manual Do Utilizador

Make sure the Paper Type, Paper Texture, and Paper Weight settings are correct. (See 

 in the Menus 

and Messages Guide located on the publications CD for detailed information about these settings.)

Make sure the paper is properly loaded in the source.

Flex paper back and forth. Do not fold or crease the paper. Straighten the edges on a level surface.

Use the following guidelines when selecting preprinted forms and letterhead paper for the printer:

Use grain long papers for best results for 60 to 90 g/m

2

 weights.

Use only forms and letterhead printed using an offset lithographic or engraved printing process.

Avoid papers with rough or heavily textured surfaces.

Use papers printed with heat-resistant inks designed for use in xerographic copiers. The ink must withstand temperatures 
of 180°C (356°F) without melting or releasing hazardous emissions. Use inks that are not affected by the resin in toner. Inks 
that are oxidation-set or oil-based should meet these requirements; latex inks might not. When in doubt, contact the paper 
supplier. 

Preprinted papers such as letterhead must be able to withstand temperatures up to 180°C (356°F) without melting or 
releasing hazardous emissions.

Check with the manufacturer or vendor to determine whether the chosen preprinted letterhead is acceptable for laser 
printers.

Page orientation is important when printing on letterhead. Use the following table for help when loading letterhead in the 
media sources.

Feed transparencies from the standard tray or the multipurpose feeder. Try a sample of any transparencies being 
considered for use with the printer before buying large quantities.

Tray 1
(Standard tray)

Printed letterhead face-up

Letterhead goes toward the front of the tray.

Tray 2
Optional 500-sheet drawer

Printed letterhead face-up

Letterhead goes toward the front of the tray.

Duplex (two-sided) printing 
using tray 1 or tray 2

Printed letterhead face-down

Letterhead goes toward the rear of the tray.

Multipurpose feeder

Printed letterhead face-down

Letterhead top edge enters first.

Manual feed slot

Printed letterhead face-down

Letterhead top edge enters first.