Fujitsu DL7400 Manual Do Utilizador

This procedure assumes that you are in setup mode. To print the selftest, 
make sure that continuous forms paper is loaded into the printer. 

Then proceed as follows: 

The <<FUNCTION>> menu should be the last printed line on 
the page. If the menu is not printed, press the ONLINE button to 
print the menu.  If you are using the HEX-DUMP function, 
press the “TEAR OFF” or “LOAD” button instead of the 
ONLINE button to print the menu.  The following 
<<FUNCTION>> menu is printed:   

 

<< FUNCTION >> 
SAVE&END MENU1    MENU2    HARDWRE  ADJUST   CONFIG   GAP-ADJ  DEFAULT  LIST     SELF-TST   
HEX-DUMP V-ALMNT  INITIAL 

 

Repeatedly press the “TEAR OFF” or “LOAD” button to 
position the cursor on the left edge of the aluminum print guide 
on SELF-TST, and then press the “

” button or the “

” button. 

The printer selects SELF-TST and starts printing. A short help 
menu is printed at the top of the page, followed by the selftest.  
Note that the printer is not online during self-test printing. 

A sample self-test page is shown in Chapter 2. To pause during 
self-test printing, press the “LOAD” button. To resume self-test 
printing, press the “LOAD” button again. 

Exit the SELF-TST function in either of the following ways: 

•  To exit SELF-TST and remain in setup mode, press the 

LF/FF button. The <<FUNCTION>> menu is then 
reprinted. 

•  To exit SELF-TST and return online, press the ONLINE 

button. The printer permanently saves any changes made 
while in setup mode and returns online. 

The self-test can also be started by turning off the printer, and then 
pressing the LF/FF button while turning the printer back on. As 
described in Chapter 2, this method is useful when you first set up the 
printer.