Fujitsu MCM3130SS Manual Do Utilizador
Installation Requirements
3-2 C156-E228-02EN
(b) IC (controller, read Amp)
IC (controller)
IC (read Am p)
Figure 3.1 Surface temperature measurement point (2 of 2)
3.1.2 Temperature requirements
Table 3.1 shows the temperature requirement at the measurement point shown in
Figure 3.1.
Figure 3.1.
Table 3.1 Temperature requirements at measurement points
Measurement point
Maximum allowable surface temperature
Inside the cartridge
55°C (*1)
IC (controller) surface
85°C
IC (read Amp.) surface
85°C
*1
60°C for the optical disk cartridges recommended by Fujitsu (except 1.3
GB).
GB).
The following describes a procedure for measuring the temperature inside a
cartridge.
cartridge.
1) At the bottom of the cartridge, open a hole large enough for the thermocouple
to be inserted as shown in Figure 3.1.
2) Disassemble the cartridge.