Fujitsu MCM3064SS Manual Do Utilizador

C156-E228-02EN 4-1 

 

This chapter describes notes on handling the drives, connection modes, settings, 
mounting the drives, cable connections, and operation confirmation and 
preparation for use after installation, and notes on demounting the drives. 

(1) General notes 

Note the following points to maintain drive performance and reliability: 

 

1) 

Shock or vibration applied to the drive that exceeds the values 
defined in the standard damage the drive.  Use care when 
unpacking.  

2) 

Do not leave the drive in dirty or contaminated environments. 

3) 

Since static discharge may destroy the CMOS devices in the 
drive, pay attention to the following points after unpacking: 

• 

Use an antistatic mat and wrist strap when handling the 
drive. 

• 

Hold  the  mounting  frame  when handling the drive.  Do 
not touch the PCA except when setting the switches. 

4) 

When handling the drive, hold both sides of the mounting 
frame. When touching other than both sides of the mounting 
frame, avoid putting force. 

5) 

Do not forcibly push up the end of the header pin of the printed 
circuit board unit when handling or setting the drive. 

(2) Unpackaging 

a)  Make sure that the UP label on the package is pointing upward and start 

unpacking on a level surface.  Handle the drive on a soft surface such as a 
rubber mat, not on a hard surface such as a desk. 

4.1 

Notes on Drive Handling 

4.2 Connection 

Modes 

4.3 Settings 
4.4 Mounting 
4.5 Cable 

Connections 

4.6 

Operation Confirmation and Preparation for Use after Installation 

4.7 Dismounting 

Drive