Fujitsu MCM3064SS Manual Do Utilizador

C156-E228-02EN 4-13 

How the drive is mounted depends on the system cabinet structure.  Determine the 
mounting procedure in consideration of the requirements of each system.  This 
section contains the general mounting procedure and check items. 

See Section 3.2 for details on mounting drive. 

1)  For a system with an external operator panel mounted, connect the external 

operator panel cable before mounting the drive in the system cabinet because 
it is difficult to access the connector after the drive is mounted. 

2)  Tighten four mounting screws to secure the drive in the system cabinet. 

The drive has ten mounting holes (both sides:  3

×

2, bottom: 4).  Secure the 

drive using the four mounting holes on both sides or the bottom. 

Use mounting screws whose lengths are 3 mm or less from the external wall 

of the mounting frame of the drive when they are tightened.  (See Figure 
3.6)  

When mounting with screws, the screw tightening torque should be 0.4 to 

0.45Nm (4 to 4.6kgf-cm). 

Be careful not to damage the parts on the PCA when mounting the drive. 

3)  After securing the drive, make sure that the drive does not touch the chassis of 

the system cabinet.  There must be at least 1.5 mm clearance between the 
drive and chassis.  (See Figure 3.6) 

Use the following cables to connect the drive to the system.  See Subsection 3.4.2 
for details on the connector positions and cable requirements. 

• 

Power supply cable 

• 

SCSI cable 

• 

External operator panel cable (if required) 

The general procedure for cable connection and notes on connecting cables are 
given below.  Pay attention to the insertion direction of each cable connector. 

 

1)  Make sure that the system power is off. 
2)  Do not connect or disconnect any cable when the power is on. 

1)  Connect the power cable.  

2)  Connect the external operator panel (only if required for the system). 

3)  Connect the SCSI cable.