Fujitsu MAS3367FC Manual Do Utilizador

C141-E198 

GL-1 

Common Command Set 
This is the standard form of SCSI logical specifications stipulated by the 
operations subcommittee of the American National Standards Institute (ANSI) 
which stipulates functions which a direct access device (magnetic disk, etc.) 
should support. 

Command Descriptor Block   
A series of data which describes commands related to input/output operations, 
sent from the initiator to the target. 

This is a command to a target to perform an input/output operation, and it is 
described as the CDB. 

The general name given to a device which is connected to the FC bus 
(input/output device, I/O controller, host adapter, etc.). 

This is a SCSI device which initiates input and output operations on the SCSI bus.  
In this manual, initiator has been abbreviated to "INIT." 

Small Computer System Interface 
The standardized input/output interface of the American National Standards 
Institute (ANSI).  [Standard No.:  ANSI X3. 131-1986] 

This is a 1-byte code displayed in the sense data and is information which 
specifies the type of error that was detected. 

When several items of error information are included in a command's completion 
status, this is information generated by the target for reporting detailed 
information on that status. 

This is a 4-bit code displayed in the sense data.  It contains information for 
classifying the type of error that was detected. 

This is 1 byte of information reported to the initiator by the target device when 
execution of each command is completed, which displays the command's 
completion state.