Fujitsu MHR2040AT Manual Do Utilizador

Página de 40
2.1  Spare Parts
Removal and Replacement Procedure
2-2
C141-F055-01EN
2.1 Spare Parts
See Table 2.1 for the model and parts numbers to order the replacement disk
drive.
Table 2.1 Model and parts numbers
Model
Part number
Formatted
capacity
Mounting screw
MHR2040AT
CA06062-B042
40 GB
MHR2030AT
CA06062-B032
30 GB
MHR2020AT
CA06062-B022
20 GB
MHR2010AT
CA06062-B012
10 GB
2.2 Disk Drive Removal
The method and procedures to demount the disk drive to check the jumper
terminal, change the jumper position, or replace the device differ depend on the
system cabinet structure.  Therefore, for actual working procedures, the specific
conditions necessary for each system must be determined.  The general removal
procedures, with notes, is as follows.
a)
Disconnect the power-interface cable.
b)
Remove the screws that attach the drive and remove the drive from the
system cabinet.
c)
When storing or transporting the drive, pack it an antistatic bag.
To protect the device from damage and prevent the worker getting hurt, observe
the following cautions and precautions in Subsection 1.1.1.
Damage or Device damage
1.
Perform any removal after the system power is completely
disconnected.  The cable must not be disconnected and the
screws that attach the drive must not be removed with the
power ON.
2.
Do not move the drive until it comes to a complete stop (about
30 s after the power is turned OFF).
3.
Perform the human body grounding to discharge any static
electricity from your body. (Be sure to wear a wrist strap)
M3 (depth 3)