Fujitsu DX8100 S2 Manual Do Utilizador

Chapter 8  Advanced Copy Management
  8.2  Functions in the Action Area for Advanced Copy

ETERNUS Web GUI User’s Guide

Copyright 2013 FUJITSU LIMITED

P2X0-1090-10ENZ0

8.2.1

Required Settings for the Advanced Copy Function

This section describes the necessary preparation that must be performed to use the Advanced Copy function
and copy session management. Perform the required settings in the following order.

■

Required settings for the Advanced Copy function (Local Copy and Remote Copy)

●

Advanced preparation

The following items must be prepared to use the Advanced Copy functions:

(1) License registration

Register a license for using the Advanced Copy function.
If a license is not registered, up to eight copy sessions can be performed (only for ETERNUS DX80 S2/
DX90 S2).

(2) Copy destination volume creation

Create a copy destination physical volume according to the amount of updated data in the copy source
volume. Create an SDV and an SDPV when performing SnapOPC+.
Refer to 

(3) Copy table size setting

Set the copy table size depending on the capacity of the copy target volume.
Refer to 

 and 

 for details.

(4) Copy priority setting

Specify the copy priority in the ETERNUS DX Disk storage system. It is not necessary to change the
default setting (Automatic Priority) for normal use.
Refer to 

.

When performing SnapOPC+, the following preparations are also required.

When using an Advanced Copy function, refer to 

 to 

register the copy license.

The RAID configuration of the copy source and copy destination can be different.

The copy source and copy destination volume encryption status must match.