Fujitsu MAX3036FC Manual Do Utilizador

2.1 Hardware Specifications

C141-E234

2-5

(*1)

For detail condition, see Section 4.1.

(*2)

Vibration applied to the drive is measured at near the mounting screw hole on the frame as much as
possible.

(*3)

At random seek write/read and default on retry setting with log sweep vibration.

(*4)

At power-off state after installation

Vibration displacement should be less than 2.5 mm.

(*5)

Input voltages are specified at the drive connector side, during drive ready state.

(*6)

High frequency noise (over 20MHz) is less than 100 mVp-p.

2.1.4 Error

rate

Errors detected during initialization and replaced by alternate block assignments are not included in
the error rate. Data blocks to be accessed should be distributed over the disk medium equally.

(1)

Unrecoverable error rate

Errors which cannot be recovered within 63 retries and ECC correction should not exceed 10 per 10

bits read.

Data loss

The drive adopts Reed-Solomon code for ECC. The sector-data is
divided into 3 interleaving sectors, and ECC is performed in each
sector where the maximum number of errors (up to 9 byte) can be
corrected. [Total maximum byte: 9 byte

× 3 ( interleave) = 27 byte]

If the error of read sector keeps allowable error byte number,
correction is performed.

However, if error byte exceeds its allowable number, correction may
not be performed properly.

(2)

Positioning error rate

Positioning errors which can be recovered by one retry should be 10 or less per 10

seeks.

2.1.5 Reliability

(1)

Mean Time Between Failures (MTBF)

MTBF of the HDD during its life time is 1,200,000 hours (operating: 24 hours/day, 7 days/week
average DE surface temperature: 50°C or less).