Fujitsu DX410 S2/DX440 S2 Manual Do Utilizador

Chapter 11  System Management
  11.2  Functions in the Action Area for System

ETERNUS Web GUI User’s Guide

Copyright 2013 FUJITSU LIMITED

P2X0-1090-10ENZ0

11.2.3.12 Setup E-Mail Notification

This function is used to configure the E-mail Notification settings for the various events detected by the
ETERNUS DX Disk storage system. 
To specify event notification, refer to 

The procedure to set a E-Mail notification is as follows:

Click [Setup E-Mail Notification] in [Action]. 

Specify the parameters, and click the [Set] button. 

●

Notification E-Mail

Notification E-Mail
Select whether to enable ("Yes") or disable ("No") the E-Mail notification function. 

Destination E-Mail Address
Specify the E-Mail destination address. 
At least one address must be specified. Up to five addresses can be specified. 
The following input condition applies:

Up to 63 alphanumeric characters and symbols (except spaces)

Comment
Input the message (comment) to be added to the E-Mail. The comment can be omitted. 
The following input conditions apply:

Up to 225 characters

Within ten lines

Alphanumeric characters, symbols, and spaces

●

Mail Server Settings

LAN Port used for SMTP Connection
Select the LAN port connecting to the SMTP server from "MNT" or "RMT". 

Sender E-Mail Address
Input the E-Mail address of the ETERNUS DX Disk storage system. 
The following input condition applies:

Up to 63 alphanumeric characters and symbols (except spaces)

When stopping the event notification via E-Mail, perform one of the following procedures. 

Disable the "Notification E-Mail"

Clear the E-Mail checkbox of the notification method using the procedure in