Fujitsu MAV2036RC Manual Do Utilizador

C141-E219 

5-3 

 

Every device that uses the SAS interface has a unique SAS address, and commands use an SAS 
address to identify each device for I/O operations.  Every HDD is assigned a unique SAS address 
before shipment from the factory, so setting of an address is not required before the HDD is used. 

 

Since mounting the drive depends on the system cabinet structure, determine the work procedures 
considering the requirements specific to each system.  The general mounting method and items to be 
checked are shown below. 

 

See Subsection 4.1 for the details of requirements for installing the HDD. 

1)  With a system to which an external operator panel is mounted, if it is difficult to access the 

connector after the drive is mounted on the system cabinet, connect the external operator panel 
cable before mounting the drive. 

 

2)  Fix the drive in the system cabinet with four mounting screws as follows: 

 

• 

The drive has 8 mounting holes (both sides:  2 

× 2, bottom:  4).  Fix the drive by using four 

mounting holes of both sides of the drive or the bottom. 

• 

Use mounting screws of which lengths inside the drive mounting frame are 2.5 mm 

±0.5 mm 

when the screws are tightened (see Figure 4.3). 

• 

When mounting the drive, be careful not to damage parts on the PCA. 

3)  Confirm the DE is not touching the frame on the system side excluding the screw installing part 

after tightening the screws. At least 2.5mm of clearance is required between the DE and the 
frame. (Indicated in Figure 4.3) 

 
4)  When using an electric screwdriver, use the screwdriver that does not apply a force on the drive 

that would exceed the drive specifications.