Fujitsu DX8100 S2/DX8700 S2 Manual Do Utilizador
Chapter 11 System Management
11.2 Functions in the Action Area for System
11.2 Functions in the Action Area for System
ETERNUS Web GUI User’s Guide
Copyright 2013 FUJITSU LIMITED
P2X0-1090-10ENZ0
935
3
Click the [OK] button.
→ The specified Box ID is registered.
4
Click the [Done] button to return to the [System Settings] screen.
End of procedure
11.2.13.4 Setup Subsystem Parameters
This function specifies the subsystem parameters.
Subsystem parameters are the information which controls the ETERNUS DX Disk storage system operation
when it is connected to hosts. The ETERNUS DX Disk storage system operates according to the specified
subsystem parameters, for all the hosts to be connected.
Subsystem parameters are the information which controls the ETERNUS DX Disk storage system operation
when it is connected to hosts. The ETERNUS DX Disk storage system operates according to the specified
subsystem parameters, for all the hosts to be connected.
The procedure to set the subsystem parameters is as follows:
Procedure
1
Click [Setup Subsystem Parameters] in [Action].
If the Box ID entered is less than 40 characters, a "#" hash key character is appended to the Box ID for
each character short. Then, the 40-digit Box ID is registered in the ETERNUS DX Disk storage system.
each character short. Then, the 40-digit Box ID is registered in the ETERNUS DX Disk storage system.
•
Do not change the setting after installing the ETERNUS DX Disk storage system, unless a maintenance
engineer instructs otherwise.
engineer instructs otherwise.
•
To set the subsystem parameters using this function, set them after stopping all host access.