Fujitsu D1411 Manual Do Utilizador
SCSI/Host RAID-Konfigurationsprogramm
Leistungsmerkmale
Standardeinstellungen im Menü Configure/View SCSI
Controller Settings
Controller Settings
SCSI-Bus Interface Definitions
Standardeinstellung
SCSI-Controller ID
7
SCSI-Controller Parity
Enabled
SCSI-Controller Termination
Enabled
Additional Options
Standardeinstellung
Boot Device Configuration
Press <Enter>
Single
Image
Master SCSI-Controller
AIC-7902 at slot 00 00:04:00
Select SCSI peripheral from which to boot
Boot SCSI-Controller
AIC-7902 at slot 00 00:04:00
Boot SCSI ID
0
Boot LUN Number*
0
SCSI Device Configuration
Press <Enter>
Sync Transfer Rate (MB/Sec)
320
Packetized
Yes
QAS
Yes
Initiate Wide Negotiation
Yes (Enabled)
Enable
Disconnection
Yes
(Enabled)
Send Start Unit Command****
Yes
BIOS Multiple LUN Support
No
Include in BIOS Scan
Yes
Advanced Configuration
Press <Enter>
Reset SCSI Bus at IC Initialization
Enabled
Display <Ctrl><A> Message During BIOS Initialization
Enabled
Extended Int 13 Translation for DOS Drives >1GByte
Enabled
POST Display Mode
Verbose
SCSI-Controller Int 13 Support
Enabled
Domain
Validation****
Enabled
Support Removable Disks under Int 13 as Fixed Disks**** Disabled
BIOS Support for Bootable CD-ROM****
Enabled
*
Die Einstellung ist nur dann wirksam, wenn Multiple LUN Support eingeschaltet (Enabled) ist.
****
Die Einstellung ist nur dann wirksam, wenn der Int 13 Support des SCSI-Controllers
eingeschaltet (Enabled) ist.
eingeschaltet (Enabled) ist.
A26361-D1411-Z120-
3-7419
Deutsch - 15