Royal Sovereign 1650C Manual Do Utilizador

  1. Set up cold film below the upper bar of the machine.

  (Set the same as  methord of the HOT film for protect paper of lower part)

  2. Set the pressure lever to the 15mm, open mode.

  3. Insert a piece of wide cardboard (guiding paper/carrier) between the rollers.

  4. Pull the film from the upper roller passing over the upper idle bar to the upper  roller  and put  it

      on the upper roller.

  5. Put the paper back of the film to the bobbin at take-up bar to rewind   the paper back.

  6. Allow some of the film with melted resin to stick to the Guiding Paper.

  7. Place the film from lower shaft beneath the film from the upper roller which is already  meiting.

     and unwind films of both rollers 30~40cm(1~1.3ft) for loosing  the  tension.

  8. Set the pressure lever to the 1mm.

  9. Set speed at 1 and press the RUN button. The films will be fed into the machine and  will  come

     out from the rear site of machine.

  10. Check the status of lamination and place the pressure lever at lamination mode.   

TAKE UP DEVICE

PAPER BACK

COLD FILM

UPPER IDLE BAR

LOWER IDLE BAR

HOT ROLLER

PAPER BACK

 

- 7 -