IBM 4400 Manual Do Utilizador
204
Chapter
7
The Super-Set Commands
Form Length and Width
The following command sets the form length:
ASCII Code SSCC K L [i
n] [m n] [l n] .
Hex Code
SSCC 4B 4C [69
n] [6D n] [6C n] 2E
Dec Code
SSCC 75 76 [105
n] [109 n] [108 n] 46
Comment
The brackets indicate optional parameters in the command
string. Do not include the brackets in your command. Only one
parameter may be used per command.
string. Do not include the brackets in your command. Only one
parameter may be used per command.
where:
i
n sets the form length in inches. n is the number of inches and
can be any number of digits, but is limited by the maximum form
length.
length.
m
n sets the form length in millimeters. n is the number of
millimeters and can be any number of digits, but is limited by the
maximum form length.
maximum form length.
l
n sets the form length in number of lines. n is the number of
lines and can be any number of digits, but is limited by the
maximum form length.
maximum form length.
. (period) is the command terminator.
The following command sets the form width:
ASCII Code SSCC K W [i
n] [m n] [c n] .
Hex Code
SSCC 4B 57 [69
n] [6D n] [63 n] 2E
Dec Code
SSCC 75 87 [105
n] [109 n] [99 n] 46
Comment
The brackets indicate optional parameters in the command
string. Do not include the brackets in your command. Only one
parameter may be used per command.
string. Do not include the brackets in your command. Only one
parameter may be used per command.
where:
i
n sets the form width in inches. n is the number of inches and
can be any number of digits, but is limited by the maximum form
width.
width.
m
n sets the form width in millimeters. n is the number of
millimeters and can be any number of digits, but is limited by the
maximum form width.
maximum form width.
c
n sets the form width in number of characters. n is the number
of characters and can be any number of digits, but is limited by
the maximum form width.
the maximum form width.
. (period) is the command terminator.
Comment
The form length and width can both be set in the same
command. The command format is as follows:
command. The command format is as follows:
ASCII Code SSCC K L [i
n] [m n] [l n] W [i n] [m n] [c n] .
Hex Code
SSCC 4B 4C [69
n] [6D n] [6C n] 57 [69 n] [6D n] [63 n] 2E
Dec Code
SSCC 75 76 [105
n] [109 n] [108 n] 87 [105 n] [109 n] [99 n] 46