Telect DNI-1B Manual Do Utilizador

Installation

DNI-1B User Manual

Telect, Inc.

108891

Issue A Rev 2

1.

Align the DNI-1B chassis mounting holes with the mounting holes 
of the network bay/rack.

2.

Install four mounting screws (two on each side) into the mounting 
holes but do not completely tighten them.

3.

Attach the hinged label holders to the 
front of the panel.

a. Slip the eyehole in the center of the 

holder over the head of the top 
mounting screw.

b. Slide the holder down on the shaft of 

this screw so that the slot in the bot-
tom fits over the shaft of the bottom 
screw.

c. Tighten both screws.

1.

Route the DCS IN cables to one side of the network bay. Tie-wrap 
the cables in place within the extender panel cable management 
brackets.

2.

Route the DCS OUT cables to the opposite side of the network bay; 
tie-wrap them the same way.

3.

Starting at the lowest DNI-1B panel in the bay/rack, lay the DCS IN 
cables over the lower tie-down bar and connect them to the NE-1 
IN termination points.

4.

Secure the DCS IN cables to the tie-down bar.

5.

Go to the next DNI1-B panel up and connect those DCS IN cables. 
Continue the procedure, connecting all DCS IN cables.