RGB Spectrum Quadra User's Guide Manual Do Utilizador
350-7951
Quadra User’s Guide
52
4
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
C
OMMAND
L
INE
I
NTERFACE
This chapter discusses Quadra control commands that provide access to all of
the unit’s functions. The following topics are discussed:
the unit’s functions. The following topics are discussed:
•
•
•
•
•
•
. . . . . . . . . . . . . . . . . . . . . . . . . . . . .
C O N T R O L O V E R V IE W
Quadra may be controlled externally via RS-232, or via the unit’s Ethernet
10/100BASE-T port, as shown below.
10/100BASE-T port, as shown below.
Figure 4-1.
Quadra
Control Methods
Quadra’s Command Set provides full system control, and with few exceptions,
all commands can be issued using either the serial port or the Ethernet port
(using a Telnet session). Exceptions are noted in the command descriptions.
all commands can be issued using either the serial port or the Ethernet port
(using a Telnet session). Exceptions are noted in the command descriptions.
Remember that control via Ethernet requires a connection using Quadra’s IP
address. In Chapter 2, refer to the “
address. In Chapter 2, refer to the “
” section for
instructions.