2WIRE 3801HGV Manual Do Utilizador
Configuring Bridge Mode
40
HomePortal 3801HGV Gateway User Guide
Configuring Broadband Settings
Resetting Statistics on Status Page
After rectifying the issues that are seen in different sections of the Status page, you must reset
this page to determine if the issue is resolved. To do this, click the Reset Statistics button at the
this page to determine if the issue is resolved. To do this, click the Reset Statistics button at the
bottom of the Status page.
Configuring Bridge Mode
Objective
To configure bridge mode.
Bridge mode is used to configure devices on the LAN with a broadband IP. When the gateway is into
bridge mode you can use a supplementary network or a third party router to handle the traffic. The
gateway will only function as a direct connection to the phone line.
bridge mode you can use a supplementary network or a third party router to handle the traffic. The
gateway will only function as a direct connection to the phone line.
Note
By default, the gateway is configured in the routing mode. When routing is disabled, the
NAT and the DHCP server are also disabled. Confirm with the ISP that the WAN protocol is
compatible with bridging mode.
NAT and the DHCP server are also disabled. Confirm with the ISP that the WAN protocol is
compatible with bridging mode.
Uncorrectable Blocks
Number of uncorrected DSL superframes that have data errors detected.
DSL Unavailable Seconds
Number of times the ISP connection was established since the statistics were
last reset, and the elapsed time since the last establishment.
last reset, and the elapsed time since the last establishment.
Parameter
Description