Lexmark 4069-XXX Manual Do Utilizador

Página de 376
2-68
Service Manual
4069-XXX
Main Drive Service Check
Service Tip: Excessive gear or main drive assembly noise is usually 
caused by a defective motor assembly or engine board.
Service Tip: If there are equally spaced horizontal lines across the 
page, go to 
WARNING:  Whenever the gearbox assembly is removed from the 
machine it must be handled very carefully. Do not allow any of the 
gears to come in contact with any metal or other hard surface to 
avoid gear damage. It is also very important not to let any dirt, paper, 
staples or other material come intact with the grease in the gearbox 
assembly.
FRU
Action
1
Main Drive Assembly 
(Excessive noise or 
vibration)
Remove the controller board and run 
a Diagnostic Print Test in the 
continuous mode. Check the main 
drive assembly for any excessive 
noise or vibration. Determine if the 
noise is in the main drive, toner 
cartridge, fuser or main drive 
gearbox. Look for any loose or worn 
parts in the developer drive 
assembly, main drive gearbox or 
fuser. Repair as necessary.
2
Main Drive Motor Assembly 
(Excessive noise, gears 
ratcheting and so on)
A service error code 936 - Transport 
Motor may be displayed. Check the 
voltage at J12-6 on the engine 
board. It measures approximately 
+5 V dc when the motor is not 
running and goes to 0 V dc when the 
motor is running. If incorrect, replace 
the engine board. If this does not fix 
the problem, replace the main drive 
motor. 
3
Main Drive Motor Cable
Check the continuity of the main 
drive motor cable. If incorrect, 
replace the cable.