Lexmark Optra E312 Manual Do Utilizador

Página de 116
14
Chapter 1: The basics
Installing memory
To install a memory card or a flash memory card, go on 
to the next section. Otherwise, you are ready to set up 
your application software and install the appropriate 
printer driver. Refer to the booklet that came with the 
Drivers, MarkVision and Utilities CD for installation 
instructions. Go to 
 for more information 
about the printer utilities and drivers.
Your printer comes with 4MB of printer memory. You 
can buy and install a 4MB, 8MB, 16MB, 32MB or 64MB 
optional memory card for a total of 68MB of printer 
memory.   
You can also install a 1MB, 2MB or 4MB optional flash 
memory card for storing downloaded fonts or macros. 
Removing the
system board shield
Before installing any of these option cards, you 
will 
need a small Phillips screwdriver to 
remove the metal 
shield covering the printer system board.  
 
1
Turn off the printer and unplug the power cord 
from the printer.
2
Disconnect the printer cable (if attached) from 
the printer.
3
Remove the print cartridge and cover it.
LA.bk  Page 14  Thursday, February 8, 2001  2:19 PM