Cisco Systems 3130 Manual Do Utilizador
32-13
Cisco Catalyst Blade Switch 3130 for Dell Software Configuration Guide
OL-13270-01
Chapter 32 Configuring SNMP
Configuring SNMP
Note
Though visible in the command-line help strings, the cpu [threshold] keyword is not supported. Though
visible in the command-line help strings, the cpu [threshold], fru-ctrl, insertion, and removal
keywords are not supported on the nonstackable switch. To enable the sending of SNMP inform
notifications, use the snmp-server enable traps global configuration command combined with the
snmp-server host host-addr informs global configuration command.
visible in the command-line help strings, the cpu [threshold], fru-ctrl, insertion, and removal
keywords are not supported on the nonstackable switch. To enable the sending of SNMP inform
notifications, use the snmp-server enable traps global configuration command combined with the
snmp-server host host-addr informs global configuration command.
You can use the snmp-server host global configuration command to a specific host to receive the
notification types listed in
notification types listed in
.
Beginning in privileged EXEC mode, follow these steps to configure the switch to send traps or informs
to a host:
to a host:
vlan-membership
Generates a trap for SNMP VLAN membership changes.
vlancreate
Generates SNMP VLAN created traps.
vlandelete
Generates SNMP VLAN deleted traps.
vtp
Generates a trap for VLAN Trunking Protocol (VTP) changes.
Table 32-5
Switch Notification Types (continued)
Notification Type
Keyword
Keyword
Description
Command
Purpose
Step 1
configure terminal
Enter global configuration mode.
Step 2
snmp-server engineID remote
ip-address engineid-string
ip-address engineid-string
Specify the engine ID for the remote host.
Step 3
snmp-server user username
groupname {remote host [udp-port
port]} {v1 [access access-list] | v2c
[access access-list] | v3 [encrypted]
[access access-list] [auth {md5 | sha}
auth-password]}
groupname {remote host [udp-port
port]} {v1 [access access-list] | v2c
[access access-list] | v3 [encrypted]
[access access-list] [auth {md5 | sha}
auth-password]}
Configure an SNMP user to be associated with the remote host created in
Step 2.
Step 2.
Note
You cannot configure a remote user for an address without first
configuring the engine ID for the remote host. Otherwise, you
receive an error message, and the command is not executed.
configuring the engine ID for the remote host. Otherwise, you
receive an error message, and the command is not executed.
Step 4
snmp-server group groupname {v1 |
v2c | v3 {auth | noauth | priv}} [read
readview] [write writeview] [notify
notifyview] [access access-list]
v2c | v3 {auth | noauth | priv}} [read
readview] [write writeview] [notify
notifyview] [access access-list]
Configure an SNMP group.