Raritan Computer 4.7 Manual Do Utilizador

Appendix D: Connecting Serial Devices to Paragon II System 
 

Press Alt + F2 to activate the Setup Screen, where you can select your 
desired serial-communication parameters (such as baud rate.) and 
local/remote output. The initial parameters will always start at their 
factory defaults, so make sure that the serial port or device to which 
AUATC is attached is temporarily configured for 9600 bps, 8 data bits, no 
parity, and 1 stop bit. (If the port or device cannot support all of these 
settings, you must temporarily attach one that can.) Also, if you want to 
perform initial configuration with a “local user station,” it must consist of a 
PS/2 keyboard and a VGA monitor. 

Available data-rate (“Baud Rate”) settings are 2400, 4800, 9600, and 
19,200 bps. You can select even, odd, or no (“None”) parity; 7 or 8 data 
bits; and 1 or 2 stop bits (but 7 data bits requires 2 stop bits). The 
terminal type is fixed at VT100. 

For local/remote connection, choose CAT 5&LOCAL if you connect the 
AUATC both to a local monitor via the VGA HD15 connector and to 
Raritan's Paragon switch via the Cat5 port (RJ45); choose LOCAL if the 
unit is connected to a local monitor only.