RuggedCom RS1600 Manual Do Utilizador

RuggedSwitch

™ User Guide 

Configure SNMP Management Stations 

This command identifies management stations that may configure the switch 
through SNMP and receive Traps from the switch. 

At shipping time and after factory reloads the switch is configured not to allow 
remote management or raise Traps.  Identify a management station to the switch 
by executing the Configure SNMP Management Stations command and 
pressing CTRL-I to create a management record, as shown below. 

You may create up to eight management stations, each of which may have 
individual settings for community strings, set access permission and sending of 
traps.  Note that all management stations created this way inherently allow get 
access and disable set access. 

My Switch                SNMP Management Stations                    Admin Access 
 
               Community String  public 
               Address            
               Set Access        Disabled 
               Send Traps        Enabled 
 
<CTRL>  Z-Help S-Shell A-Apply 

Community String 

The community string this management station is authenticated by.  

Address 

The management station IP address.   

Set Access 

If enabled, this management station may change configuration parameters. 

Send Traps 

The management station will be sent SNMP traps if this setting is enabled.  The 
traps issued are summarized in Appendix C – SNMP Trap Summary. 

 

RuggedCom