Fujitsu eLux NG S26361-F2600-L134 Manual Do Utilizador

 

 

 

 

 

 

Build # 27

  

101

 

 

1.  A VPN session is initiated from the local shell. There is no graphical user interface. 
2.  To initiate the session, open a local shell. At the bash prompt type: vpnclient 

connect sample

 

3.  If connection was successful, you will be requested to enter a group name and 

password and a user name and password (depending on the configuration). 

4.  Once the tunnel has been established, the local shell displays the status of the 

connection as well as potential error messages (see Figure 64). 

5.  You can run applications (ICA, RDP, emulations etc.) from the eLux NG starter as 

usual. The connections will be established through the secure tunnel. 

6.  To disconnect, type CTRL-C or close the local shell. 

 

After successfully establishing a session from a local shell, you can configure an application to 
run Cisco VPN automatically when the device starts. This section is optional. 

1. From 

the 

 tab, click New. In the Application Definition dialog box, 

click the Local tab. 

•  Name: Enter “VPN Connect”. 
•  Application: Select XTERM. 
•  Parameter: Enter –e vpnclient connect sample 
•  Application Restart: Leave deselected 
•  Start automatically: Click to select 

 

2.  From now on when the Thin Client starts, the window VPN Connect will automatically 

open and a VPN session will be initiated.  

Figure 64: Initiating an encrypted session with Cisco VPN 

3. The 

 window displays the status of the connection. The window  is 

displayed only for the duration of the VPN session. Error messages are not displayed. 

4.  To disconnect, use CTRL-C or close the VPN Connect window.