Fujitsu eLux NG S26361-F2600-L134 Manual Do Utilizador
Códigos do produto
S26361-F2600-L134
www.
myelux
.com
eLux
®
NG
Build # 27
113
recommend drive E or later) and set it to read-only (if required). Click Apply and OK
to save the advanced ICA parameters.
to save the advanced ICA parameters.
4. At this point, you can connect to the MetaFrame server. The client drive appears in
Windows Explorer under the letter you mapped it to.
Troubleshooting
Do not configure advanced ICA settings for an open or disconnected session! Log off first.
If the desired client drive does not appear in the ICA session, and you have multiple USB
devices attached to the Thin Client, check that the mount point you used is correct.
Do not configure advanced ICA settings for an open or disconnected session! Log off first.
If the desired client drive does not appear in the ICA session, and you have multiple USB
devices attached to the Thin Client, check that the mount point you used is correct.
4.2.6 COM
Port
Mapping
Client COM port mapping allows devices attached to the Thin Client’s serial ports to be used
from ICA sessions on a MetaFrame server. This allows local devices like modems, serial
printers, and bar-code scanners to be used by applications running on the MetaFrame server.
To map a COM port, you must know the device name of the serial port on the client.
The serial port device name always begins with “/dev”:
• /dev/ttyS0
from ICA sessions on a MetaFrame server. This allows local devices like modems, serial
printers, and bar-code scanners to be used by applications running on the MetaFrame server.
To map a COM port, you must know the device name of the serial port on the client.
The serial port device name always begins with “/dev”:
• /dev/ttyS0
: external serial port
• /dev/ttyS1
: internal serial port
• /dev/usb/tts/0
: USB v. 24 converter (PL2303 chip only)
Note: Device names are case sensitive. The letters shown here in lower case must be typed in
lower case.
lower case.
Which serial ports are available depends on your hardware platform.
To map a Thin Client COM port to an ICA session, first configure the advanced ICA settings in
the eLux NG starter, then configure the Citrix MetaFrame ICA server settings.