Fujitsu RX600 S5 Manual Do Utilizador
RX600 S5
Operating Manual
121
CSS components
Non-hot-plug components
8.2
Non-hot-plug components
V
CAUTION!
●
The actions described in this section may only be performed by
personnel with the appropriate technical training. (The device can be
seriously damaged if it is opened without authorization or if repairs
are attempted by untrained personnel.)
personnel with the appropriate technical training. (The device can be
seriously damaged if it is opened without authorization or if repairs
are attempted by untrained personnel.)
●
The circuit boards and soldered parts of internal options are exposed
and can be damaged by static electricity. Before handling them, first
touch a metal part on the server to discharge static electricity from
your body.
and can be damaged by static electricity. Before handling them, first
touch a metal part on the server to discharge static electricity from
your body.
●
Do not touch the circuitry on boards and soldered parts. Hold the
metallic areas or the edge of the circuit boards.
metallic areas or the edge of the circuit boards.
●
Touch only the specified part of the printed circuit board. Failure to do
so may cause injury. It may also cause failures.
so may cause injury. It may also cause failures.
●
Please observe the safety information in
.
If a defective non-hot-plug component is detected (for more information,
see chapter
see chapter
and the "ServerView
Suite Local Service Concept - LSC" manual on the ServerView Suite
DVD 2), proceed as follows:
DVD 2), proceed as follows:
Ê
Exit all applications and shut down the server properly (see section
).
Ê
Pull all power connectors out of the power outlets.
Ê
Remove the server from the rack (see section
) and place the server on a
table, for example.