Fujitsu fi-6140 Manual Do Utilizador

3

1.

Place the scanner at its installation site.

For details on the scanner's dimensions and required 

installation space, refer to chapter 9  "Installation 

Specifications" of "fi-6140/fi-6240 Operator’s Guide" 
in the Setup CD-ROM.

For fi-6140, go to Step 3.

2.

Unlock the Transport lock.

The carrier unit inside the fi-6240 is fixed in place with 

the transport lock to prevent the scanner from being 
damaged during transportation.

To unlock the transport lock, slide the transport lock 

switch on the scanner front.

3.

Attach the ADF paper chute.

Hold the ADF paper chute and insert its tabs into the 

corresponding slots in the scanner as shown in the next 
figure below. Let the ADF paper chute down to fit into 

position.

The Side guides of the ADF paper chute have to face 
up. 

4.

Connect the AC adapter.

1) Connect the AC cable to the AC adapter.

2) Connect the AC adapter connector to the scanner’s DC 

inlet.

3) Plug the AC cable into an outlet. If you want to plug it 

into a two-slot outlet, use the supplied adapter plug.  

 

Connect either with the USB cable or the SCSI cable.

 

ATTENTION

Use only the supplied AC adapter.

Lock

Release

ADF paper chute

Side guide

Tab

2

1

ATTENTION

Before plugging the adapter plug into an outlet, be sure to 
establish a ground.

HINT

The Function Number Display and LED of the operator panel 
on the scanner may flash for an instant when the AC cable is 
plugged into an outlet. This is a phenomenon due to the 
initial diagnosis, but not a failure.

ATTENTION

This scanner is provided with two interfaces: Ultra SCSI and 
USB 2.0 /1.1. Connect only one of the USB or SCSI cable.