Fujitsu M3097G+ Manual Do Utilizador

6 – 1

If a problem occurs, use Table 6.1 to resolve the problem.

Problem

No power

Read operation
does not start.

Pictures and
photographs are
not read cor-
rectly.

Characters and
lines are not
read correctly.

Image is dis-
torted or un-
clear.

Possible cause

The power switch was not
turned on.

The power cable was not
connected correctly.

——————————

The ready indicator was not
on (in the manual mode for
M3097E+).

The documents were not
placed on the ADF correctly.

The ADF was not closed
completely.

The interface cables were not
connected correctly.

Halftone processing was not
selected.

The document bed, docu-
ment holding pad, or inside
ADF is dirty.

Simple binarization was not
done.

The document bed, docu-
ment holding pad, or the
inside of the ADF is dirty.

The document was moved
during the read operation.

The document was not in
contact with the glass.

Response

Press the power switch.

Connect the power cable correctly.

Turn off the power once and make an
attempt to turn on the power again.  If the
power is not turned on, contact your
Fujitsu service representative.

If the ready indicator is on, press the start
button.

Insert the first a few pages into the slot.

Make sure that the ADF is closed com-
pletely.

Connect the interface cables correctly.

Select a halftone mode from the host
system, or use the halftone button if
M3097E+ is used.

Clean the dirty parts as explained in
Section 5.3, “Cleaning.”

Select a binarization mode from the host
computer, or use the halftone button if
M3097E+ is used.

Clean the dirty parts as explained in
Section 5.3, “Cleaning.”

Keep the document cover closed during
reading so that the document will not be
moved.

Adjust the document so that it is in
contact with the glass.