Honeywell SC1000 Manual Do Utilizador

 page 42      008-0608-00

6.2.4 

INSTALL CHANNEL

 

Menu Item

This menu item will add an Input, Output or Virtual channel as the next highest chan-
nel number in the system.

Input or Output Channel 
Installation Procedure

Before installing an Input or Output card, make certain that you know the “card type”
(a two-digit hexadecimal number) of the card you wish to install.

Use the following procedure to install an Input or Output card:

1) When the instrument is in the RUN mode, use the [ENTER] button to change 
which channel the display is monitoring.  Note the highest channel number that is 
presently installed. The new circuit card for the new channel will be installed as 
the next channel number.

2) Examine the circuit card to be installed and orient it as shown below.  On it you 
will find the address jumper block.

Figure 6-1: Address Jumper Block Location

3) Change both address jumpers to match the next available channel in the 
instrument according to the chart below.  Do not skip any channel numbers.

Figure 6-2: Address Jumper Settings

Installing a channel will cause it to use the “default” or “empty” configuration 
information for that channel.  All other channels are unaffected.
Any calibration data, SensoCode mathematics programs, display setup, 
or other information for that channel will be erased to default values.

Use Electrostatic Discharge (ESD) precautions when unpacking and handling 
circuit boards.
Failure to comply with these instructions may result in product damage.