Roland JV-1010 Manual Do Utilizador

■

Before you switch on the power, check the following.

• Are peripheral devices connected correctly?
• Is the volume level on the JV-1010 and the connected external 

equipment turned down all the way?

Press the POWER switch on the JV-1010 to switch on the power.

After 

 is displayed, the unit starts up in the same state it was 

in when the power was last turned off.

¬fig.1-07

Switch on the power to the connected external equipment.

Play sounds on the JV-1010 and turn the VOLUME knob to 
adjust the volume on the JV-1010 and the external equipment.

fig.1-08

■

Before you switch off the power, check the following.

• Is the volume level on the JV-1010 and the connected external 

equipment turned down all the way?

• Have you saved the sounds or other data you’ve created? (p. 48)

Switch off the power to the connected external equipment.

Switch off the POWER switch on the JV-1010.

Once the connections have 
been completed (p. 18), turn 
on power to your various 
devices in the order 
specified. By turning on 
devices in the wrong order, 
you risk causing malfunction 
and/or damage to speakers 
and other devices.

If the power was turned off 
while in the Rhythm Set 
mode (RHYTHM), the unit 
starts up in the Performance 
mode (PERFORM).

This unit is equipped with 
a protection circuit. A brief 
interval (a few seconds) 
after power up is required 
before the unit will operate 
normally.

Be careful not to turn the 
volume up too high. 
Excessive volume levels are 
not only inconsiderate to 
others around you, but may 
damage external equipment 
or cause hearing loss.

Turning the VOLUME knob 
up all the way may result in 
distortion for some sounds.

You can also play sounds 
on just the unit itself by 
pressing the VOLUME 
knob (Phrase Preview, p.