Lexmark 642e MFP Manual Do Utilizador
Reports
26
Using MFP menus
Universal Setup
These menu items are used to specify the height and width of the Universal Paper Size. When the height and width for
Universal Paper Size are specified, the MFP uses the Universal setting like other paper sizes, including support for duplex
and n-up. For more information on n-up, see Multipage Print.
Universal Paper Size are specified, the MFP uses the Universal setting like other paper sizes, including support for duplex
and n-up. For more information on n-up, see Multipage Print.
Reports
Note: After a report prints, the MFP returns to the home screen.
Each report prints using some standard print settings, such as:
•
one copy
•
portrait orientation
•
600 dots per inch (dpi) print resolution
•
normal print area
•
no separator sheets
•
duplex printing is set off
•
multiple page printing is set off
•
toner darkness is set to eight
•
media source is the user default
Menu item
Purpose
Values and descriptions
Units of Measure
Determines the unit of measure
used to enter the Universal Height
and Width.
used to enter the Universal Height
and Width.
Inches
Millimeters
Inches is the US default, and
Millimeters is the international default.
Millimeters is the international default.
Portrait Width
Sets the portrait width of the
universal media.
universal media.
Note: If the value set exceeds the
maximum width, the MFP uses the
maximum value allowed in inches or
millimeters.
maximum width, the MFP uses the
maximum value allowed in inches or
millimeters.
3–14.17 inches in
0.01 inch increments
0.01 inch increments
76–360 mm in 1 mm
increments
increments
Shows either inches or millimeters
from the Units of Measure setting;
8.5 inches is the US default, and
216 mm is the international default.
from the Units of Measure setting;
8.5 inches is the US default, and
216 mm is the international default.
Portrait Height
Sets the portrait height of the
universal media.
universal media.
Note: If the value set exceeds the
maximum height, the MFP uses the
maximum value allowed in inches or
millimeters.
maximum height, the MFP uses the
maximum value allowed in inches or
millimeters.
3–14.17 inches in
0.01 inch increments
0.01 inch increments
76–360 mm in 1 mm
increments
increments
Shows either inches or millimeters
from the Units of Measure setting;
14 inches is the US default, and
356 mm is the international default.
from the Units of Measure setting;
14 inches is the US default, and
356 mm is the international default.
Feed Direction
Specifies the feed direction of the
Universal Paper Size.
Universal Paper Size.
Short Edge*
Long Edge
Feed Direction is only shown if the
Long Edge value is available. Long
Edge exists if the longest edge is
shorter than the maximum physical
width that the tray can accommodate.
Long Edge value is available. Long
Edge exists if the longest edge is
shorter than the maximum physical
width that the tray can accommodate.