Vinotemp VVTT--FFUULLLLKKEEGG Manual Do Utilizador

9 

 

1 7 6 2 1   S o u t h   S u s a n a   R o a d ,   R a n c h o   D o m i n g u e z ,   C a l i f o r n i a   9 0 2 2 1  

i n f o @ v i n o t e m p . c o m  

 

 
 
Installation Of the Keg Coupler 

•  Insert the keg coupler provided into the locking 

neck of the beer keg and turn it clockwise to lock 

into position, making sure the keg coupler is in 
the closed position. (See Figure 3) 

Figure 3 

 Air Line Hose 

•  Attach the end of the red hose provided to the hose connection on the keg coupler. 

Secure hose by using the connector and make sure there are no leaks. 

 
Installation of Protective Metal Plate  

•  This plate should always be installed when the keg is in place to protect against 

unnecessary damage to the floor of the cabinet liner.  

 

Installation of the Beer Keg 
•  Position the beer keg directly in front of the open door. Using keg handles only, 

carefully lift the beer keg. (See Figure 4) 

•  To place the beer keg inside the cabinet, brace your knees behind the beer keg. Lift 

the front of the keg just enough so the front edge of the keg is resting on the front 

edge of the Beer Dispenser bottom cabinet. (See Figure 5) 

•  Grasp the keg handles and slide it all the way into the cabinet.  

 
 

 
 

 
 
 

 
 

 
 

 
                              Figure 4                                                 Figure 5 

NOTICE: THE BEER TOWER ASSEMBLY OF YOUR UNIT COMES WITH A FLAT MYLAR 

WASHER. YOUR UNIT MAY NOT REQUIRE THE USE OF THIS WASHER AS TOWER IS 
DESIGNED FOR A TIGHT AND SECURE FIT. HOWEVER, WHILE INSTALLING THE TOWER 

TO THE UNIT THIS WASHER CAN BE USED FOR A TIGHTER FIT IF NECESSARY.