GE JVB93 Manual Do Utilizador
2
READ AND FOLLOW THIS SAFETY INFORMATION CAREFULLY.
READ AND SAVE THESE INSTRUCTIONS
READ AND SAVE THESE INSTRUCTIONS
SAFETY PRECAUTIONS
IMPORTANT SAFETY INFORMATION.
READ ALL INSTRUCTIONS BEFORE USING.
READ ALL INSTRUCTIONS BEFORE USING.
WARNING –
TO REDUCE THE RISK OF FIRE,
ELECTRIC SHOCK OR INJURY TO PERSONS,
OBSERVE THE FOLLOWING:
OBSERVE THE FOLLOWING:
A.
Use this unit only in the manner intended
by the manufacturer. If you have questions,
contact the manufacturer.
by the manufacturer. If you have questions,
contact the manufacturer.
B.
Before servicing or cleaning unit, switch
power off at service panel and lock the service
disconnecting means to prevent power from
being switched on accidentally. When the
service disconnecting means cannot be
locked, securely fasten a prominent warning
device, such as a tag, to the service panel.
power off at service panel and lock the service
disconnecting means to prevent power from
being switched on accidentally. When the
service disconnecting means cannot be
locked, securely fasten a prominent warning
device, such as a tag, to the service panel.
C.
Do not use this unit with any solid-state speed
control device.
control device.
D.
This unit must be grounded.
CAUTION –
For general ventilating use only.
Do not use to exhaust hazardous or explosive
materials and vapors.
materials and vapors.
WARNING –
TO REDUCE THE RISK OF
INJURY TO PERSONS IN THE EVENT OF A RANGE
TOP GREASE FIRE, OBSERVE THE FOLLOWING*:
TOP GREASE FIRE, OBSERVE THE FOLLOWING*:
A.
SMOTHER FLAMES with a close-fitting lid,
cookie sheet or metal tray, then turn off the
burner. BE CAREFUL TO PREVENT BURNS.
If the flames do not go out immediately,
EVACUATE AND CALL THE FIRE
DEPARTMENT.
cookie sheet or metal tray, then turn off the
burner. BE CAREFUL TO PREVENT BURNS.
If the flames do not go out immediately,
EVACUATE AND CALL THE FIRE
DEPARTMENT.
B.
NEVER PICK UP A FLAMING PAN—
You may be burned.
You may be burned.
C.
DO NOT USE WATER, including wet
dishcloths or towels—a violent steam
explosion will result.
dishcloths or towels—a violent steam
explosion will result.
D.
Use an extinguisher ONLY if:
1.
1.
You know you have a Class ABC
extinguisher, and you already know
how to operate it.
extinguisher, and you already know
how to operate it.
2.
The fire is small and contained in the
area where it started.
area where it started.
3.
The fire department is being called.
4
. You can fight the fire with your back to
an exit.
* Based on “Kitchen Firesafety Tips” published
by NFPA.
WARNING –
TO REDUCE THE RISK OF A
RANGE TOP GREASE FIRE:
A.
Never leave surface units unattended at high
settings. Boilovers cause smoking and greasy
spillovers that may ignite. Heat oils slowly on
low or medium settings.
settings. Boilovers cause smoking and greasy
spillovers that may ignite. Heat oils slowly on
low or medium settings.
B.
Always turn hood ON when cooking at high
heat or when cooking flaming foods.
heat or when cooking flaming foods.
C.
Clean ventilating fans frequently. Grease
should not be allowed to accumulate on fan
or filter.
should not be allowed to accumulate on fan
or filter.
D.
Use proper pan size. Always use cookware
appropriate for the size of the surface
element.
appropriate for the size of the surface
element.
WARNING –
TO REDUCE THE RISK OF FIRE,
ELECTRIC SHOCK OR INJURY TO PERSONS,
OBSERVE THE FOLLOWING:
OBSERVE THE FOLLOWING:
A.
Installation work and electrical wiring must be
done by qualified person(s) in accordance
with all applicable codes and standards,
including fire-rated construction.
done by qualified person(s) in accordance
with all applicable codes and standards,
including fire-rated construction.
B.
Sufficient air is needed for proper
combustion and exhausting of gases through
the flue (chimney) of fuel burning equipment
to prevent back drafting. Follow the heating
equipment manufacturer’s guideline and
safety standards such as those published by
the National Fire Protection Association
(NFPA), and the American Society for
Heating, Refrigeration and Air Conditioning
Engineers (ASHRAE), and the local code
authorities.
combustion and exhausting of gases through
the flue (chimney) of fuel burning equipment
to prevent back drafting. Follow the heating
equipment manufacturer’s guideline and
safety standards such as those published by
the National Fire Protection Association
(NFPA), and the American Society for
Heating, Refrigeration and Air Conditioning
Engineers (ASHRAE), and the local code
authorities.
C.
When cutting or drilling into wall or ceiling,
do not damage electrical wiring and other
hidden utilities.
do not damage electrical wiring and other
hidden utilities.
D.
Ducted fans must always be vented to the
outdoors.
outdoors.
WARNING –
TO REDUCE THE RISK OF FIRE,
USE ONLY METAL DUCTWORK.
•
Do not attempt to repair or replace any part of
your hood unless it is specifically recommended
in this guide. All other servicing should be
referred to a qualified technician.
your hood unless it is specifically recommended
in this guide. All other servicing should be
referred to a qualified technician.