Fujitsu MAT3073NC/NP Manual Do Utilizador

C141-E201

5-11

5.4 Mounting

Drives

5.4.1

Check before mounting

Reconfirm if the setting terminals are set correctly according to Table 5.8 before mounting the NP
model drives in the system cabinet. For setting terminals location, see Section 5.3.

The NC model drives do not require the following check.

Table 5.8

Setting check list (NP model only)

No.

Setting contents

(Check item)

Setting

position

Check Remarks

SCSI ID

CN2

1 - 2

3 - 4

5 - 6

7 - 8

(SCSI ID = __)

Upper bus
(DB 8 to 15 PI)
not connected

Write protect

CN2 9 - 10

Short

Open

Motor start mode

CN2 11 - 12

Short

Open

Force Narrow

CN2 13 - 14

Short

Open

Force single ended

CN2 15 - 16

Short

Open

Setting

terminal

CN2

Terminator power
supply

CN2 23 - 24

Short

Open

5.4.2 Mounting

procedures

Since mounting the drive depends on the system cabinet structure, determine the work procedures
considering the requirements specific to each system. The general mounting method and items to
be checked are shown below.

See Subsection 4.1 for the details of requirements for installing the IDD.

1) With a system to which an external operator panel is mounted, if it is difficult to access the

connector after the drive is mounted on the system cabinet, connect the external operator panel
cable before mounting the drive.

2) Fix the drive in the system cabinet with four mounting screws as follows:

•

The drive has 10 mounting holes (both sides: 3

2, bottom: 4). Fix the drive by using

four mounting holes of both sides or the bottom. (See Figure 4.5)

•

Use mounting screws whose lengths inside the drive mounting frame are 5.0 mm or less
when the screws are tightened (see Figure 4.4).

•

When mounting the drive, be careful not to damage parts on the PCAs.

3) Check to ensure that the DE is not touching the frame on the system side after tightening the

screws. At least 2.5mm of clearance is required between the DE and the frame. (Indicated in
Figure 4.4)

4) When an electric driver is in use, less than device specifications must be used.