Vertex Standard FT-2000 Manual Do Utilizador
Page 80
FT-2000 O
PERATING
M
ANUAL
A number of interesting and useful features are available during Electronic Keyer operation.
Setting the Keyer Weight (Dot/Space:Dash) Ratio
The Menu may be used to adjust the Weight for the built-in Electronic Keyer. The default weighting is 3:1 (a dash is
three times longer than a dot or space).
three times longer than a dot or space).
U
SING
THE
B
UILT
-
IN
E
LECTRONIC
K
EYER
CW M
ODE
O
PERATION
1. Press the [MENU] button to enter the Menu mode.
2. Rotate the Main Tuning Dial knob to select Menu
2. Rotate the Main Tuning Dial knob to select Menu
item “060 AIA WEIGHT.”
3. Rotate the [SUB VFO-B] knob to set the weight
to the desired value. The available adjustment range
is for a Dot/Space:Dash ratio of “2.5” ~ “4.5” (de-
fault value: “3.0”).
is for a Dot/Space:Dash ratio of “2.5” ~ “4.5” (de-
fault value: “3.0”).
4. When you are finished, press and hold in the
[MENU] button for two seconds to save the new
setting and exit to normal operation.
setting and exit to normal operation.
Main Tuning Dial Knob
[SUB VFO-B] Knob
[MENU] Button
Selecting the Keyer Operating Mode
The configuration of the Electronic Keyer may be customized independently for the front and rear KEY jacks of the
FT-2000. This permits utilization of Automatic Character Spacing (ACS), if desired, as well as the use of the
electronic keyer via the front jack and a straight key or computer-driven keying line via the rear panel.
FT-2000. This permits utilization of Automatic Character Spacing (ACS), if desired, as well as the use of the
electronic keyer via the front jack and a straight key or computer-driven keying line via the rear panel.
1. Press the [MENU] button to enter the Menu mode.
2. Rotate the Main Tuning Dial knob to select Menu
2. Rotate the Main Tuning Dial knob to select Menu
item “052 A1A F-TYPE” (for the front KEY jack)
or “054 A1A R-TYPE” (for the rear-panel’s KEY
jack).
or “054 A1A R-TYPE” (for the rear-panel’s KEY
jack).
3. Rotate the [SUB VFO-B] knob to set the keyer to
the desired mode. The available selections are:
OFF
OFF
: The built-in Electronic Keyer is turned off
(“straight key” mode).
buG
: Dots will be generated automatically by the
keyer, but dashes must be sent manually.
ELE
: Both dots and dashes will be generated au-
tomatically when you use your paddle.
ACS
: Same as “ELE” except that the spacing be-
tween characters is precisely set by the keyer
to be the same length as a dash (three dots in
length)
to be the same length as a dash (three dots in
length)
4. When you are finished, press and hold in the
[MENU] button for two seconds to save the new
setting and exit to normal operation.
setting and exit to normal operation.
Main Tuning Dial Knob
[SUB VFO-B] Knob
[MENU] Button
Inter-character
spacing to short
Morse
“E” & “T”
Morse
“E” & “T”
ACS “ON”
ACS “OFF”