Philips PPX4150A/INT Manual Do Utilizador

Do not make any changes or settings that are not 
described in this user manual. Physical injury or damage 
to the device or loss of data can result from improper 
handling. Take note of all warning and safety notes indi-
cated.

The unit is for indoor use only. The device should be 
placed securely on a stable, flat surface. Position all 
cables in such a way that no one will stumble on them, 
thus avoiding possible injuries to persons or damage to 
the device itself.

Do not plug in the device in moist rooms. Never touch 
the mains cable or the mains connection with wet 
hands.

The device must have sufficient ventilation and may not 
be covered. Do not put your device in closed cabinets 
or boxes.

Do not place the machine on soft surfaces such as table-
cloths or carpets and do not cover the ventilation slits. 
Otherwise the device could overheat or catch fire.

Protect the device against direct sunlight, heat, large 
temperature fluctuations and moisture. Do not place 
the device in the vicinity of heaters or air conditioners. 
Observe the information on temperature and humidity 
in the technical data.

When the device is running for a long period of time, 
the surface becomes hot and a warning symbol appears 
on the projection. The device switches automatically to 
stand-by mode when it gets too hot. After the device 
has cooled down, you can continue playback by pressing 
any key.

Do not allow liquids to enter into the device. Switch off 
the device and disconnect it from the mains supply if liq-
uids or foreign substances end up inside the device. 
Have the unit inspected by a technical service depart-
ment.

Always handle the unit with care. Avoid touching the 
lens. Never place heavy or sharp objects on the projec-
tor or the power cable.

If the projector gets too hot or emits smoke, shut it 
down immediately and unplug the power cable. Arrange 
for your device to be investigated by a technical service 
centre. To prevent the spread of fire, open flames 
should be kept away from the device.

Under the following conditions, a layer of moisture can 
appear inside the device which can lead to malfunctions:

• if the device is moved from a cold to a warm 

area;

• after a cold room is heated;
• when this device is placed in a damp room.

Proceed as follows to avoid any moisture build-up:

1 Seal this device in a plastic bag before moving it to 

another room, in order for it to adapt to room con-
ditions.

2 Wait one to two hours before you take the device 

out of the plastic bag.

The device should not be used in a very dusty environ-
ment. Dust particles and other foreign objects may 
damage the unit.

Do not expose the device to extreme vibrations. It may 
damage the internal components.

Do not allow children to handle the device without 
supervision. The packing materials should be kept out of 
the hands of children.

Use only the enclosed power adapter (see chapter 
Appendix / Technical Data). Check whether the mains 
voltage of the power supply matches the mains voltage 
available at the setup location. This equipment complies 
with the voltage type specified on the unit.

The capacity of the battery diminishes with time. If the 
device functions only with the power supply, the battery 
is defective. Contact an authorised service centre to 
replace the battery.

Do not try to replace the battery yourself. Incorrect 
handling of the battery or using the wrong type of bat-
tery can cause damage to the device or cause injury.

Switch the device on or off using the power switch 
before removing the power supply from the socket.

Turn off the device and remove it from the power sup-
ply before cleaning the surface. Use a soft, lint-free 
cloth. Never use liquid, gaseous or easily flammable 
cleansers (sprays, abrasives, polishes, alcohol). Do not 
allow any moisture to reach the interior of the device.

Do not try to replace the battery yourself. 

This device is equipped with an high power 
LED (Light Emitting Diode), which emits very 
bright light. Do not look directly into the pro-
jector lens. This could cause eye irritation or 
damage.

Do not use the device over a longer time at 
high volume – especially when using head-
phones. This could lead to the risks of hearing 
damage.

PPX4150_UM_EN_253617510.book  Page 4  Vendredi, 6. février 2015  2:49 14