Ryobi Outdoor 3000 PSI Manual Do Utilizador

Página de 26
19
TROUBLESHOOTING
                 PROBLEM 
              CAUSE 
              SOLUTION
Engine fails to start 
1.  Engine switch is in the off position 
1.  Move switch to start.
 
.  No fuel in tank 
.  Fill tank.
 
3.  Spark plug shorted or fouled 
3.  Replace spark plug.
 
4.  Spark plug is broken (cracked 
4.  Replace spark plug. 
 
     porcelain or electrodes broken)
 
5.  Ignition lead wire shorted, broken,  
5.  Replace lead wire or attach to spark 
 
     or disconnected from spark plug 
     plug.
  
6.  Ignition inoperative                                6.  Contact authorized service center.
Engine hard to start 
1.  Water in gasoline 
1.  Drain entire system and refill with  
 
      
     fresh fuel.
 
.  Engine is under or over choked 
.  Adjust choke as necessary.
 
3.  Weak spark at spark plug 
3.  Contact authorized service center.
Engine lacks power 
1.  Dirty air filter 
1.  Clean or replace air filter.
Detergent fails to mix with spray 
1.  Detergent injection hose is not 
1.  Insert injection hose into detergent   
 
      properly submerged 
     storage bucket.
 
.  High pressure nozzle attached 
.  Use low pressure nozzle (black) to 
 
 
     apply detergent.
Pump doesn’t produce pressure 
1.  Low pressure nozzle installed 
1.  Replace with high pressure nozzle.
 
.  Inadequate water supply 
.  Provide adequate water flow.
 
3.  Spray wand leaks 
3.  Replace wand.
 
4.  Nozzle is clogged 
4.  Clean nozzle.
 
5.  Pump is faulty 
5.  Contact authorized service center.
Machine doesn’t reach high 
1. Diameter of garden hose is too  
1.  Replace with 3/4 in. garden hose. 
pressure 
    small
 
.  Water supply is restricted 
.  Check garden hose for kinks, leaks,  
 
 
     and blockages.
 
3.  Not enough inlet water 
3.  Open water source full force.
 
4.  Wrong nozzle is attached 
4.  Attach the high pressure nozzle.