Lexmark 1200 Guia Da Instalação
45
Install memory and network options
Installing a
hard disk
Two hard disk options are available from Lexmark:
•
A hard disk with a ribbon cable already installed.
•
An adapter ribbon cable alone that you can use to
install any other Lexmark or third-party hard disk
meeting the following criteria:
install any other Lexmark or third-party hard disk
meeting the following criteria:
–
2.5-inch platter
–
ATA-2 (IDE) interface
–
Maximum thickness of 13 mm (.51 in.)
Attaching an
adapter ribbon cable
If you bought an adapter ribbon cable for a separate hard
disk, follow these instructions to attach the cable to the
disk. If your disk already has a ribbon cable attached, skip
to “Installing the disk” on page 46.
disk, follow these instructions to attach the cable to the
disk. If your disk already has a ribbon cable attached, skip
to “Installing the disk” on page 46.
The adapter ribbon cable comes with screws for securing
the hard disk to the system board.
the hard disk to the system board.
1
Locate the 47-hole connector on the ribbon cable.
One of the 50-hole connectors has three holes
plugged.
plugged.
2
Carefully attach the 47-hole connector to the disk
connector.
connector.
When correctly installed, the stripe on the ribbon
cable should be oriented as shown.
cable should be oriented as shown.
3
Stripe