Lexmark W810 Guia Do Utilizador

Printer consumables

If you agreed to return your old fuser to Lexmark in order to pay a reduced price for the 
new one, place the old fuser in the new fuser box and mail to Lexmark. Otherwise, discard 
the old fuser.

If you’ve attached an optional finisher to your Optra W810, your printer’s finishing capabil-
ities include stapling. The printer’s staple capacity is 5,000 staples per cartridge, which 
you can purchase in boxes of three. The finisher can staple packets of up to 50 sheets of 
paper, and outputs them into bin 2. 

When the printer determines that approximately 40 staples are left in the cartridge, it dis-
plays a 

 message. The staple low counter then increments by one every time 

one of the remaining staples is used, and when the staple low limit has been reached, the 
printer alerts you that it is time to change the staple cartridge:

If the Staples Empty Alarm menu item in the Finishing Menu is set to Single or 
Continuous, the printer stops printing and sounds a series of beeps. The message 

 appears on the display. If you ignore this message and press 

 to 

continue printing, the print job may not be stapled.

If the Staples Empty Alarm is set to Off, the printer displays a 

 mes-

sage and continues to print, but does not staple the pages.

Changing the staple cartridge should clear the 

 message from the display. If 

it does not, check to make sure the stapler is installed correctly. (For instructions on 
inserting a new staple cartridge, refer to the 

User’s Reference. For information about 

ordering staple cartridges, see page 137.)

After you insert a new staple cartridge, the printer automatically prepares the stapler to 
begin stapling again. 

 appears on the display as the printer tests the sta-

pler on a single sheet of paper. (Refer to the 

User’s Reference for more information.) Then 

the printer resumes printing. 

Protective tape

Sheets of staples