Lexmark W810 Guia Do Utilizador

Changing printer settings

Use the Setup Menu to configure a variety of printer features.

Printer Language

= PCL Emulation*
= PS Emulation

The printer language defines how the computer communicates 
with the printer. Your computer uses printer languages, such as 
PCL emulation and PostScript emulation, to send print data to 
the printer. Setting a printer language as the default does not 
prevent the software application from sending print jobs that 
use the other printer language.

Power Saver

= Disabled
= 1…120 (20*)

The Power Saver setting lets you reduce power usage when 
the printer is idle by determining the length of time (in minutes) 
the printer waits after a job is printed before it goes to a reduced 
power state.

If you select a numeric Power Saver value, the 

 

message replaces the 

 message and becomes the new 

printer default when the printer is in a Ready state. Both 
messages indicate the printer is ready to receive jobs.

If your printer is in constant use, select a high setting. Under 
most circumstances, this keeps the printer ready to print with 
minimum warm-up time.

Set Power Saver to 1 to put the printer in Power Saver mode 
one minute after it finishes a print job. This uses much less 
energy, but requires more warm-up time for the printer. If your 
printer shares an electrical circuit with room lighting and you 
notice lights flickering, you may want to set Power Saver to 1.

If you want a balance between energy consumption and a 
shorter warm-up period, select a Power Saver value between 1 
and 120 minutes.

* Factory default