Lexmark W810 Guia Da Instalação
157
Set up network addresses
TCP/IP
For instructions on other ways to set the IP address not documented
in the following sections, refer to the
in the following sections, refer to the
Drivers, MarkVision and Utilities
CD. Click
View Documentation
and then click
MarkNet Print Servers
.
Setting the IP address,
netmask, and gateway
You must assign an IP address, netmask, and gateway to the
MarkNet print server for other network devices to find the printer on
the network.
MarkNet print server for other network devices to find the printer on
the network.
•
If you have DHCP, the proper address values are automatically
assigned. To verify the assignment has happened, print a net-
work setup page and make sure the IP address, netmask, and
gateway appear as non-zero.
assigned. To verify the assignment has happened, print a net-
work setup page and make sure the IP address, netmask, and
gateway appear as non-zero.
•
If you don’t have DHCP, there are other methods you can use
to manually assign the address, such as the printer operator
panel, static ARP and telnet, RARP and telnet, BOOTP, or
MarkVision or another Lexmark utility. Instructions for three of
these methods follow.
to manually assign the address, such as the printer operator
panel, static ARP and telnet, RARP and telnet, BOOTP, or
MarkVision or another Lexmark utility. Instructions for three of
these methods follow.
Printer operator panel
You can use the printer operator panel to set the IP address, net-
mask, and gateway inside the print server. You must be standing at
the printer to use this method.
mask, and gateway inside the print server. You must be standing at
the printer to use this method.
Note:
Press
Menu>
until you
see the correct menu item, and
then press
then press
Select
.
1
Select
Network Menu
,
Network Option X
,
Network X Setup
,
TCP/
IP
,
Set IP Address
.
X
designates the network connector you are using for the print
server. For example,
Network Option 2
appears on the operator
panel display if a MarkNet card is installed in network connec-
tor 2.
tor 2.
2
Use the menu buttons to set the IP address.
Press
Select
to advance to the next segment in the address.
Press
Menu>
to increase the number by one. Press
<Menu
to
decrease the number by one.
3
Press Select until the word
SAVED
appears briefly.
4
Set IP Netmask
, and then again
to
Set IP Gateway
.