Fujitsu S500M Guia Do Utilizador

ScanSnap S500M for Macintosh Getting Started | 5  

 
This chapter describes necessary preparations before using 
ScanSnap. 

ATTENTION

 

Do not connect the scanner to your personal 
computer before installing “ScanSnap Manager.” 
If you connect the scanner before installing 
ScanSnap Manager, it will not operate correctly. 
Refer to Chapter 2 for details on the installation of 
ScanSnap Manager. 

 

When you unpack the scanner package, make sure that all 
parts are included. 
Refer to the packing list included in the scanner package 
for contents. 

This section describes the name and function of parts. 

„ 

Front Side   

* You can also use the scanner without the Stacker. 

„ 

 

„ 

 

 

HINT

 

For the Document Specifications, refer to the 
“ScanSnap S500M Operator’s Guide” stored in 
ScanSnap Setup CD-ROM.   

 

ATTENTION

The scanner turns on/off automatically when you 
open/close the Paper chute. 
To turn off the scanner with the cover opened, 
press the [POWER] button. 

 

 

Paper chute 
Open the paper chute to use 
the scanner. 

Ö 

Opening the paper chute 

turns ON the scanner. 

Stacker 
Extend this part to use the stacker 
as shown in the figure. 

Ö 

Sheets of paper are ejected from the ADF onto the stacker.

Cover open lever 
Pull this lever to open the ADF. 

Paper chute 
Open the paper chute and load 
documents onto it for scanning 
documents. 

Side guide 
Adjust these guides to fit the 
width of the paper, so that the 
paper does not skew. 

ADF  
(ADF: Automatic Document  
Feeder) 

Seal: After installing ScanSnap Manager onto 

your computer, remove this seal to connect 
the scanner to the PC. 

AC adapter connector 

USB connector 

[SCAN] button 
Start scanning. 

[POWER] button 
Hold down 1 sec. to turn 
on/off the power supply. 

Power lamp 

 

Indicate the scanner status. 
Blue: Ready 
Blue (Blinking): Scanning 
Orange: Error 
Light out: Power 

off