Manualsbrain.com
  1. Manuais
  2. Marcas
  3. Toshiba
  4. TDP T360
  5. Manual Do Utilizador

Toshiba TDP T360 Manual Do Utilizador

Download
Página de 29
6
7
Operations
Basic operations
1
 Turn on the power.
Turn on the power by following the instructions in “
Turning the power on” 
p.24
.
2
 Select the language and the lamp power (When using the 
first time).
When the projector is used for the first time after purchase, the start menu for language 
(to display the menus and messages on the screen) and lamp power selection and 
configuration is displayed in English. (If the screen is out of focus, adjust it according to 
the step 
6
.)
1
 Use the  ,  , 
 or   
button to select the desired language and 
press the   button.
English
French
German
Italian
Spanish
Portuguese
Russian
Swedish
Turkish
Polish
Norwegian
Finnish
Czech
Hungarian
Greek
Danish
Dutch
Rumanian
Japanese
Chinese (simplified)
Chinese (traditional)
Korean
Indonesian
Message for setup confirmation is displayed in a selected language. 
Then, the menu for lamp power selection and configuration is displayed. It is 
automatically set as Standard. To change the setting, follow the step 
.
 Use the   or   button to select the lamp power and press the   
button.
The lamp power, if selected, will be toggled without pressing the
   
button. The display 
automatically disappears in a few seconds.
 Notes
When the projector is turned on the next time, the start menu does not appear upon 
startup. However, if [
Reset all] is executed from the Default setting 2 menu 
p.42
, 
the start menu will be displayed the next time when the power is turned on.
The language can also be set via the 
Display setting menu 
p.38
 and Lamp power 
via the 
Default setting 2 menu 
p.42
.
This owner’s manual assumes that English has been selected.
3
  Activate the connected device.
Turn on and start the connected device such as a computer.
4
  Press the INPUT button.
An image of the connected equipment is projected.
Each time you press the 
INPUT button, it switches to the input of the connected 
equipment that is outputting video signals.
•
•
•
 Notes
When [
Auto input search] is set to [Off] in the Default setting 1 menu 
p.41
 
(factory setting is [
On]), the Input select menu appears if you press the INPUT 
button 
p.41
.
If no signal is being output from the connected equipment, pressing the 
INPUT 
button does not change the input and “There is no other input signal.” will appear.
5
 Projector placement angle adjustments
The placement angle and the height of the projected image can be adjusted by the 
foot adjuster.
1
 Lift up the front of the projector to 
the desired angle, then press the foot 
adjuster release button.
The foot adjuster extends. Release the button 
to lock the position.
 To fine adjust the angle, twist the foot 
adjuster.
 To adjust the horizontal angle, use the 
right and left tilt adjusters.
To stow the foot adjuster, hold up the projector while pressing the foot adjuster 
release button, then slowly lower the projector.
 Note
When [
Auto keystone] is set to [On] in the Default setting 1 menu, the keystone 
distortion will automatically be corrected based on the projector placement angle. If 
you do not desire the automatic keystone correction, set [
Auto keystone] to [Off].
6
 Adjusting the screen size and focus
1
 Use the zooming lever to adjust the 
screen size.
 Use the focusing ring to adjust the 
focus.
7
 Adjusting the volume with the 
   buttons
The speaker volume can be adjusted when an audio signal is being input.
•
•
•
•
Focusing ring
Zooming lever